12 gram pump mag build

[RT Lover]

Nice marker!

[captian pinky]

so i just got that roll pin in and of course it will take the strength of Hercules to get that pin in the 6 pak. any recommendations that are not risky.

first attempt was duck tape and vise grips. it was close but would take a lot of work to get it to slide to the middle i think.

[wetwrks]

so i just got that roll pin in and of course it will take the strength of Hercules to get that pin in the 6 pak. any recommendations that are not risky.

first attempt was duck tape and vise grips. it was close but would take a lot of work to get it to slide to the middle i think.

Hot and cold...try putting the pin in the freezer for a while to shrink it...if that doesn't work do it again and look at trying to heat what you are putting it into to expand that.

[captian pinky]

putting it in the freezer will not shrink it the amount i need to make it smaller. its a roll pin and designed to be compressed and then put in.

[need4reebs]

use your drill press to press the roll pin in…same as a trigger pin or any other pin.