Pneu kits ready.

[knownothingmags]

im about to get my restock of emag batteries in,
I was wondering if anyone is interested in me stocking pneu kits, ones with the msv2 and the mpa-3 ram.

let me know your thoughts.

thank you,
KNM

[knownothingmags]

or am I stepping on mag79's toes.
I didn't know if he is around offering the kits.

[Nobody]

Get them and put them out. Mag79 is very sporadic in his time here, from what i seen. I know, i want a kit, just to have.

[knownothingmags]

its would be the msv2, mpa3 ram, barb fittings, trigger rod, lp hose and mounting screws and trigger stops if I can get them.
and the magnet mod if people want it.

[knownothingmags]

all parts ordered minus set screws and trigger rod but those will get here before anything else even if I order them later.
ill throw up a dealer thread when I get the parts in hand.

what length set screw for trigger stop screws with nylon tip do people use?

[knownothingmags]

parts ordered.
now just need to wait for them.

[cougar20th]

what length set screw for trigger stop screws with nylon tip do people use?

Off the top of my head I don't remember what length I used on the M86's. But they were just 4-40 thd 18-8 Stainless Steel setscrews. No nylon tip.

[knownothingmags]

Off the top of my head I don't remember what length I used on the M86's. But they were just 4-40 thd 18-8 Stainless Steel setscrews. No nylon tip.

got it.
der, just needed to look

thank you.

[luke]

I use 6-32 and I've seen others use 8-32.
Length depends on the trigger but 1/4' is a good average.

[knownothingmags]

I use 6-32 and I've seen others use 8-32.
Length depends on the trigger but 1/4' is a good average.

8-32 on what an emag trigger. that seems big.

[luke]

I dont recall what trigger it was but I have seen them.
Personally if I were you I would avoid the 4-40 because it may be hard for guys at home to hand tap. On a milling machine it's not an issue but it may be an issue for the inexperienced to hand tap.

[knownothingmags]

I dont recall what trigger it was but I have seen them.
Personally if I were you I would avoid the 4-40 because it may be hard for guys at home to hand tap. On a milling machine it's not an issue but it may be an issue for the inexperienced to hand tap.

yeah my thoughts exactly, ill offer the 4-40 to people that have say the trigger already tapped.

[luke]

Set screws are cheap in bulk so it would be easy to stock a few sizes and lengths then people can choose what they want, LMK if you need a source for hardware.

[knownothingmags]

Set screws are cheap in bulk so it would be easy to stock a few sizes and lengths then people can choose what they want, LMK if you need a source for hardware.

yeah after I left that last post I came to this realization too.
ill have many sizes stocked.

[knownothingmags]

I almost have all the parts in to make the pneu kits
20151117_121038.jpg20151117_121053.jpg20151117_121113.jpg20151117_121124.jpg