Best method to remove trigger pin?

[Zeropjc]

Hey guys I'm just wondering whats everyone's method of removing the trigger pin on mag frames?

[zondo]

I use a hammer and a nail set that is approximately sized for the trigger pin. The nail set is curved so it doesn't move a whole lot when its struck with the hammer.

[Loguzzzzzz]

I use one of these. It is a spring loaded center punch. You just push on it and it will drive the pin out. no need for a hammer that way.

[going_home]

Phillips screwdriver........

[zondo]

Neat... I like that, John.

[Tunaman]

Phillips screwdriver........

Butcher!
An 1/8" punch is the correct tool. It should be pressed in and out also.

[Nobody]

I use sarcasm, ridicule & rhetoric to get mine to move. Takes a little extra but doesn't mar the surface.

[Tunaman]

I use sarcasm, ridicule & rhetoric to get mine to move. Takes a little extra but doesn't mar the surface.

This method also works...

[GoatBoy]

I use sarcasm, ridicule & rhetoric to get mine to move. Takes a little extra but doesn't mar the surface.

Yeah but that usually results in a trigger pin with low self esteem. Next thing you know, it will be doing drugs and hanging out with Tippmanns...

[Cyco-Dude]

mallet and a 1/8" punch. put the frame on a roll of tape laying on it's side to make room for the pin and you tap it out.

[zondo]

mallet and a 1/8" punch. put the frame on a roll of tape laying on it's side to make room for the pin and you tap it out.

I usually use the cement on the porch. That way I'm sure the frame doesn't slip around on the ground causing the nail set to jump around and scar the frame.

[Cyco-Dude]

you mean you put a frame on cement, that hard rock-like stuff that can easily scratch the hell out of aluminum parts, and then beat on it with a nail and hammer??

i feel sorry for your parts...

[zondo]

you mean you put a frame on cement, that hard rock-like stuff that can easily scratch the hell out of aluminum parts, and then beat on it with a nail and hammer??

i feel sorry for your parts...

Oops... I forgot to add the sarcasm emoji.

I was inspired by the "Mechanic Fails" memes.

[Cyco-Dude]

lol oh! ok, that's better then.

[going_home]

Oops... I forgot to add the sarcasm emoji.

I was inspired by the "Mechanic Fails" memes.

What is this icy windsheild you speak of ?