Nummech.com

[Tunaman]

Hrm, a Magnus gas-through frame? I'm intrigued. Tunaball '22 reveal?

Darn, I thought it was going to be the uniframe BigEvil teased with a rendering back in 2012...
https://www.automags.org/forums/show...27#post2798027

Nope. It is not me. That is all I know.

[BigEvil]

Hrm, a Magnus gas-through frame? I'm intrigued. Tunaball '22 reveal?

Darn, I thought it was going to be the uniframe BigEvil teased with a rendering back in 2012...
https://www.automags.org/forums/show...27#post2798027

Completely forgot about that one. I literally have a folder full of stuff we were messing with.

[Olsson]

Nope. It is not me. That is all I know.

Crappers. I figured it was a design of yours, with your earlier coy answer. I would really have liked a Tuna frame.

[Walking Stick]

Completely forgot about that one. I literally have a folder full of stuff we were messing with.

I've had rail-less on my mind this year and screen grabbed that years ago along with those 'Cocker hinge-frame conversions. One would be perfect with XMT's ULE bodies.

I always thought it'd be cool if a gas-thru frame had an upward extension on the right side of the tang next to the thumbscrew hole. Like a tombstone. The top of this tombstone would have a banjo hole to accept a quick-strip banjo bolt going straight into the valve. A 1/8" NPT insert/plug drilled and tapped to accept the RT banjo bolt would be super convenient. Biggest drawback to that additional hunk of aluminum would be aesthetics with some body/rail combos and overall rail compatibility - no rear winged RT Pro, Emag, most RPGs... But if the tombstone was a bolt-on affair there could be versions that swung out further to clear various rails.

Or maybe a Nummech N-Mag just needs a "bridge" on the N-Mag frame that takes a small thumbscrew banjo bolt at the valve for tool-less disassembly. A more permanent version of the double CCM fitting setup most seem to run.

[captian pinky]

that is basically was done with the ccm fittings. which i guess could be done as a single piece but really the hard part is getting the fitting heights right.

[Bunny]

Any news on those bodies? Did they ever come out?

[trbo323]

..... Any specific body? He has multiple

I'm waiting on the n mag frames

Sent from my motorola edge 5G UW (2021) using Tapatalk

[Bunny]

I can't remember the names off the top of my head, but any of them. I saw a small trickle of these over the last few years, but I was wondering if Andy ever released them to the masses. I'm not on facebook so I don't really check too often, but I dont think I ever saw them officially release yet.

[captian pinky]

I can't remember the names off the top of my head, but any of them. I saw a small trickle of these over the last few years, but I was wondering if Andy ever released them to the masses. I'm not on facebook so I don't really check too often, but I dont think I ever saw them officially release yet.

several made it out, but not many. Pyro, necro, edge and then even less of the minimal body he did.

[Pizza_Monger]

I was worried about it for a while until I saw the autococker parts come out last year. So nummech lives on.

I really hope the automag parts become available again. I feel that there is a lot of pent up demand for his stuff or at the very least more gas through frames.