ok, i just got done shooting my new super bolt, and after 100 shots w/o the barrel on, i looked at the bolt. near the bottom, there were some nicks on the delrin. i was wondering if i should take some fine sand paper and sand them down until its flush. heres a picture of the bolt(crappy because of digital camera).
-
-
its near the bottom, it looks white because of the flash of the camera. -
i wouldnt worry to muchComment
-
It's not going to affect anything being that low. Just make sure you're using the honed spring that came with it. Also, take a close look at the mainbody washer inside the mainbody. If there are any burrs on it, smooth them out with a needle file.Comment
-
I think tom said that most of the wear on a super bolt comes from shooting it without a barrel. The bolt "wiggles" around without the barrel there to support it and shaves off little peices of delrin. Try to dryfire with your barrel on in the future. As the for the wear it's nothing but if it bugs you sand the monkey down a bit
GeckoAka tech
Chuff
ChuffComment
Comment