SFL proto warp breach test results..

[liigod]

cleenest lookking warp ive ever seen

[AllAmericanMag]

Wow, your gun Kicks ***!

[kilaueakid]

Oregon PB,
You are exactly right and that is what I am trying to redesign now. Have the entry higher and actually go in straight from the side, and than put an angle off of that piece going down towards you hopper/warp feed.

In theroy this should work, and this may also solve the problem of a ball backing out of the breach, as there would be a little ledge there. Will know more later this week.

kila

[Fred]

Lemme get this straight...

You machined that yourself?!?!

I think that in light of the possibility of breaks inside, it would be a good idea to be able to quickly clean out the breech, but I don't know how long it takes to actually remove the entire thing...
A plug might cause more problems, functionally, and aesthetically.
Doing the feed horizontal instead of on the angle might solve the problem of backing out, but I like the lower angle better... maybe that's just me.
Did you think of doing one of those Gated feeds like the IR3s have now???

[dansim]

whered you get that dealie around your battery case?

[thei3ug]

if you don't have a lot of room to put a detente, check out palmer's phoon detentes. they are a wire with a delrin ball on it. the ball goes in a hole through a tube, and the wire is shaped to wrap around it.

[BTAutoMag]

i still like the look of that gun

[DJSOLID]

I love second powerfeed plug idea, kilaueakid. Perfect.

[FooTemps]

What kind of ACE are you using!?!?

[BTAutoMag]

wow foo i thihk this is an official record. r u the first person to pass 1000 twice...

[FooTemps]

SOMEONE ANSWER MY FRICKEN QUESTION!!! IS THIS TESTED WITH THE AGD ACE!?!?!?

bah... Forgot my question... Yes, it probably is a record since I'm the only person to have my post count permanently reset...

[Johnny Bravo]

Calm down Foo,
No it was not tested with the ACE mainly because of the fact that the balls now roll over the ACE instead of falling on top, hence, the ACE sees the ball prematurely in the breech. So Kila just turned it off. Not like he needs it with a warp...

[ah137]

don't be stupid

Originally posted by kilaueakid
I ended up turning the ACE off and not using it. To be honest, I think if you are using a Warp, an ACE system is not neccesary. Especially if you have a 12volt mod done to your warp.

Make sure you READ the whole post before you post!!!!!!!!!!!. This was in the first post by kila!!!!

It is better to be thought a fool than to open your mouth and remove all doubt.

[aint_got_no_nubbinz]

i have a silver sfl emag and am looking for this mod for my gun. Could you make me one of those, i will be willing to give you a few $$ for it if necessary. I woould however like it to say SFL on it and also have the feed horizontal instead of angled. Anyway i hope you can make one of these for me soon.

[kilaueakid]

sorry man, I just had 1 made for myself. You will be better off getting one directly from AGD or Shocktech when they become available.


kila