Is lvl 10 slower than other levels?

[Restola]

What is lvl10? FooTemps?

[FooTemps]

Originally posted by Restola
What is lvl10? FooTemps?

::raises hand:: OOO OOO! I KNOW! IT'S A RUBBER CHICKEN!

but realistically... do a search! you'll figure it out

[Magluvr]

Originally posted by AGD
STOP RIGHT THERE!! LVL10 does not reduce the firing rate to 11 bps it will still do 20 bps as the HALO vid shows.

AGD

Thanks Tom!!!! But I still don't see what everyone is saying baout it reducing ball breakage, my minimag hasn't broken a single ball so far (knock on wood) but I have only put 500 PMI's through it too. So what the thing about Mags breaking balls??????

[BTAutoMag]

Originally posted by Magluvr
So what the thing about Mags breaking balls??????

Mags dont break balls. they never break balls. its the people who short stroke the mag that breaks the balls.

[MagNumPI]

My mag kills balls as of late, i'm going to do a complete overhaul on her. no i am not short stroking, my on/off pin is getting stuck i nthe on/off valve (bought it used, kid didn't apreaciate what he had).

[BTAutoMag]

Originally posted by MagNumPI
(bought it used, kid didn't apreaciate what he had).

thats how i bought mine. so i started upgrading to fix the problem. well now i have another problem... i cant... stop... upgradeing!!!

[rx2]

Originally posted by MagNumPI
My mag kills balls as of late, i'm going to do a complete overhaul on her. no i am not short stroking, my on/off pin is getting stuck i nthe on/off valve (bought it used, kid didn't apreaciate what he had).

I have noticed inconsistancy in the fit of the small teflon o-rings in the on/off assembly. Some seem too loose, causing leaks, and some too tight, making the pin sticky. Perhaps this is the problem. Particularly, the one in the on/off bottom has given me trouble in the past.

[WickeDKlowN]

actually, it will not fit all AGD guns, you cant forget about the sydarm

[WickeDKlowN]

i dont really need the lvl 10 upgrade cause the only time i break is when i either out shoot my revvy, or when i get going too fast and short stroke. but i will get it anyway, incase, god forbid, i have to use the dreaded BE paint, or some other sh...crappy paint.

[MagNumPI]

RX2

Thats exactly whats happening. i took it to bits found the on off sticking. You still have that problem? I'm replacing every oring on it and hopefully the new teflon orings will be proper for the on off.

[rudy]

that on off oring can cause problems in my old mag I found the trigger pretty stiff on a new oring so I would put the on off pin in dremmel and then spin it in the teflon orin to loosen it up a bit. when i obtained my hyerframe I had a problem with the onoff catching on the oring in my retro so i put in a new one and it worked. then i bought the emag quad oring and put it in and it works great now.

[rx2]

I have it a little, depending on what o-rings I use. It is strange, as some that I switched were leaking, as they were too loose, and some were too tight. Fortunately, I was able to rummage through a couple of parts kis to find pretty much the right one. It is a little stiff right now, but I am going to see if I can't break it in. I'll let you know how that goes.