Help Intellifeeding!

[AssassN]

I am almost done but i have been noticing a red wire in addition to the white and the strands. Should i just ignore it or do i use this too? BTW i am scared to "tap" into my revi wire. What did u do when u cut thro ur revi wire to make sure u didn't ruin it?

[MrAirgunRT]

I don't know about the red wire in addition to the white and strands. Just ignore it til you are done, and see if it works. But all I did to tap into the revvy wire was be REALLY careful.

[AssassN]

Thanks gunna go try.

[AssassN]

Ok i did it all but i didn't connect the wire to the battery terminal. The intellifeed isnot working, is this why?

[MrAirgunRT]

The manual is on airgun.com, i don't wanna give you any wrong info. But I think you have to connect it to the battery terminal or near where switch it either one.

[AssassN]

ok i shuld of done it in the first place

[AssassN]

I had the wrong cord :-\ *sigh*. I had the steeo and i needed mono. I will try again and post results 2marrow.

[z-grip]

you can use that cable it will work, just abbandon the third wire, the job only requires 2 conductors.

[AssassN]

I will take a pic of it on wednesday. Then u smart guys tell me what i did wrong.