can i intela feed a 9v VL 2000?
if so how?
if so how?
-
-
try running a search. you can use the same setup as a warp intellifeed. There are different ways of accomplishing what you want.. -
i still have my vl 2ooo and its working on its 3rd mag. i have thought about this cause the optics are gettin very old and unreliable.unclip the optics from the neck of the feeder and cut them off, go to radio shack and get a little jack that you can solder to the wires and plug into your intelliframe. then just leave the power switch on all the time. i dont have an intelliframe so i havnt actually done this.you may want to see if anybody else agrees with me before you start cuttin stuff up
Comment
-
sounds aboutnright to me, if you know how to use a multimeter you could figure it out but finding the normally open set of wires and just wiring your switch to those wires and forgeting about the eyemicromag
z-grip
ans phase 2 valve
venturi bolt
shaved on off valve
kapp drop foward dz II
10" and 16" boomstick
114 4500 Air America Apocolypse 2K
oldschool 18volt rev
custom intellifeed connection (this was tough)Comment
-
or
convert to an 18v
link aint workin
but i post laterComment
Comment