if I were to place an oring on the power tube tip of the mag out side of it to help seal the bolt and power tube how much effeicency woudl I save and woudl it cause to much friction? Has someone looked into this before? and why not include it on the final of lvl 10
- AO: We are back from the dead... again! After an 18 day outage, we are finally alive and well. Who knew how complicated updating software/databases from 2008 would be. I still have alot of tweaks to make, but my main goal was getting everything patched and updated to 2026. Vbulletin 6 has changed alot since 2008 so we will have a ton of new features to dig into.
Comment