H.A.L.O. B/Warpfeed combo...problems?
I have a newly upgraded HALO and a Warpfeed. The HALO A and the Warpfeed rocked as a combination, but once I installed the HALO B, it seemed to completely mess up the way the Warpfeed worked.
No longer will the Warpfeed feed. It would "bind" up after only a few shots and the wheel wouldn't turn, though I was using fresh Plainview 9.6V on a freshly oiled wheel with 32-degrees (non-Advantage) paint. After emptying out the feed tube and priming the Warpfeed, the unit would jam once more. The only item that changed in the system was the HALO. I didn't spend too much time fooling with it since I was the host of the day and had already missed two games, but after 20 minutes of fooling with it, I pulled off the Warpfeed and went with the HALO.
It seems that there may be some issue with the force with which the new HALO send out the paintballs. I can certainly notice the positive pressure of the ball stream when I ran the HALO by itself at the store, but don't know if this is the cause.
Any other experience?
No longer will the Warpfeed feed. It would "bind" up after only a few shots and the wheel wouldn't turn, though I was using fresh Plainview 9.6V on a freshly oiled wheel with 32-degrees (non-Advantage) paint. After emptying out the feed tube and priming the Warpfeed, the unit would jam once more. The only item that changed in the system was the HALO. I didn't spend too much time fooling with it since I was the host of the day and had already missed two games, but after 20 minutes of fooling with it, I pulled off the Warpfeed and went with the HALO.
It seems that there may be some issue with the force with which the new HALO send out the paintballs. I can certainly notice the positive pressure of the ball stream when I ran the HALO by itself at the store, but don't know if this is the cause.
Any other experience?
)try adjusting (increasing)the sensativity level.
Comment