does anyone know the approximate PSI the level 10 runs at....
thanx....
(just wondering cause TK stuck his tongue in breach)
thanx....
(just wondering cause TK stuck his tongue in breach)
-
-
Re: Level10 Psi.....
Originally posted by Jonno06
(just wondering cause TK stuck his tongue in breach)
WHEN??
I wana see it, their aint a video of it is there?
Black Warp Left E-mag #EM00163
emagnum board
14in freak
12v smoke warp w/ interlink
drilled 12v revy w/ JMJ impeller and WAS turbo rev board
shocktech drop
AGD flatline dovetail adaptor
68 3000 flatline
***soon to be***
emagnum body rail
black powder coat
custom grips from Frymarker -
The pressure is the same. The ball still needs the same energy to go 300fps as before, if anything the pressure has gone up because more energy is being wasted on moving the bolt.To be an AGD supporter, one cannot be an AGD bigot. -Nero
Truth is a complex thing. One must govern by simplicity. -M. Mercier, special counsel to his Majesty for domestic matters. The Brotherhood of the Wolf
"You can't outrun Death forever, but you can make the bastard work for it."
Comment
-
yep still the same pressure.Did you hear about the new european weapons contracts? France is going to make the wooden sticks Spain making the little white flags
Comment
-
so whats the speed?Comment
-
Speed of what? The bolt vents of a little bit of pressure prior to completely sealing causing the bolt to go slow while venting then full speed and propelling the ball after the vent stage. I'm sure the bolt is a little slower top end than without lvl10 but not much. Nothing to worry about.
Comment
-
The bolt speed is about 4fps in the first stage and then I believe it gets up to about 10fps in the second stage.Comment
-
thanx black,and everyone....
i mean,I had an Impy owner ask me what psi its running at,so what would i tell him?Comment
-
I believe it dumps like 120-160 psi for the shot..I could be wrong thoughComment
-
Tell him...
That the gun's operating pressure means squat to wether or not it brakes paint.
Also tell him that the firing pressure actually moving the ball is very different to the operating pressure behind the valve or in the firing chamber.
Tell him the pressure that fires the ball is about the same as in the Impulse but that the level 10 with a retro valve can shoot at upto 26bps without drop off and is less likely to break paint now than his impulse!
Maybe he will learn something
manikeComment
-
Look at the high pressure gauge on your N2 tank and tell him that. It gets regged down where the paintballs fly at 300fps. @ 26bps (for the RT Valve)Originally posted by Jonno06
i mean,I had an Impy owner ask me what psi its running at,so what would i tell him?
Or, if you run CO2 like me, it's roughly 850psi, depending on the weather. And that gets regged down (internally, where there are no gauges) to where the paintballs go 300fps @ 12bps (for the classic valve)
Otherwise it runs at the same, or close to stock bolt.Shaun Nelson --- old, fat, slow.... did I mention lazy? I ate all the pies
I disable .signatures Apparently you do not.Comment
Comment