lvl 10 on boo-yaah mag

[Lone Brain Cell]

My setup
Regular valve, 2.0 carrier 2 shimms middle spring (Cut one).


Since I have bought my mag (2 years ago) I have always been tentitive in pulling the trigger too fast (Just in case of short stroking) I just love the Boo-Yaa lvl 10 combo, I have a cheap marker that keeps up with most Angels AND IS MORE ACCURATE!!!!

btw : I had to get a new Reg piston.

[meat]

Well i was a little slow but i finnaly ordered my lvl 10( i wanted to wait til agd got everything sorted out) and i havent tinkered with it enought to get it to work, i have a carrier that fits, so i put in 2 shims and middle spring , didnt fire , put in smallest spring and if would work fine but bolt was to slow you reset and wouldnt get 5 bps! so problem can be solve by recharging battery cause there might not be enough juice to make fire ( boo-yahh guys know how when you run out of battery juice that it will fire and then wont fire the next 2 shots and then fire again and so on and so on)(which i like cause if you run dry in the middle of a game you can still do stuff much like emag's manual switch but not as good) anyway, another way to fix it might be to cut middle spring so it is somewhere between length of middle and small , of corse to amount of shims might be the problem also , so many things to adjust , hmm how do i go about having adg put it in(im lazy) and i love all of you seg-z beasts. thanks for reading my ramblings of the things floating in this mystical ocean i call a mind trapped inside my brain.

[vamicromagger]

Thanks for the info Lone Brain Cell, but you raised another question,
"btw : I had to get a new Reg piston. "
was that needed to get level 10 working or just after you had it for a while?

[Lone Brain Cell]

"btw : I had to get a new Reg piston. "

This was because of the increased pressure needed with the lvl 10. I couldnt get my velosity up over 250 without it venting out the back, a few bux and she's a ripper!

[meat]

got it qorking it was the low battery

[vamicromagger]

Thanks for the Help

Never could get lvl x to work on the mag w/ Booyaah, thought it might have been the Reg. Piston like Lone Brain Cell mentioned, It would either leak and shoot or not shoot at all. Tried it on my Retro Micro and got it on the second try, 1.5, 2 shims, and middle spring. Thanks again for the help guys.