Warped.... Mayhem???

[dansim]

i just saw a warped mayhem last sunday...it was gold or yellow

[nicad]

..well, it works. great actually. just need a slightly weaker spring i think (ie one of yours).

iv tossed a coupla pics up for everyones enjoyment.. weee...

see the vents in the bolt oring groove... its a must! (for my setup..) origional piston included for compairison.


everything all pretty and happy

[SyntaxError]

Originally posted by RT_Luver
i while back ago at my field they had a Nova for sale. that thing was FUGLY. ahd to be the ulgiest thing I've ever seen....SERIOUSLY. it had like a freak barrel on it or something. kinda odd.

well, I dont see how it could have a freak on it, as nova barrels were all brass and produced in little or no aftermarket places. but they shot well, very well, I almost bought one if it weren't for classic mags being as cheap as they were few years ago. Now i'm VERY happy with my purchase

[SyntaxError]

dammit nicad! beat me by like 5 seconds!!

[nicad]

oh yes and BTW- for those of you who thought stiking your fringer in a non lvl10 mag was bad news.... heres what about .2 seconds in a mayhem can do.
the pen is (was) pretty hard plastic with a rubber sleeve..
SNAP!

[keiphers]

All I can say is wow.

[sniper1rfa]

danism, you didnt happen to be carrying a blue warped e-mag at CCPB sunday (or were there with somebody who had one), and see a gold mayhem with a mysteriously blue trigger, did you.. (and some shrimpy 15 year old holding it, possibly shooting it over the chrono)?

how didja like my gun? if it was indeed you, you were the ONLY person there who had EVER seen one (albiet pics).

darn, it WAS you, your in cape cod and you said cape is the best place in mass. d'oh! shoulda said something, you coulda shot it! lol
just another reason for AO jerseys....

nicad, swweeeeet! i am definately making something like that. have you run run paint through that sucker (specifically somewhere between the bolt and the breech wall)?

[nicad]

yep held a ball with tape in the breach... acted LUST like a mag lvl10 (but closed bolt..).
with the ball suspended half in/out of the breach, and the marker gased up, the bolt moved forward and stopped on the ball.. repeated trigger pulls resulted in a small amount of air firing out the bolt and then the bolt moving back/forward just to stop on the ball again. over and over about 50 times on the same ball.. the ball started getting a little mal-formed and indentions in it from the repeated pressure.
remove the ball (or chamber a ball), and it acts just like a regualr mayhem.. even though i can just barely tell the bolt is moveing a little slower going forwadr in 1st stage.. thus the need for a slightly lighter spring..

out!

[sniper1rfa]

my spring will be way too light, its almost half the pressure of the stock one. 3/8 piston will chop a ball with my spring, as that will put like 10 pounds on the ball. no good. it might work, but you will probably have to make a smaller piston (im making mine 9/32, so it never ever ever chops). also, if you make another piston, make it the same except make the small piston start where the old threaded part starts. i have noticed that withought the 1/2" of hose on the back of the old piston, the bolt sits way way back when open. with the new piston and the half inch spacer, it should work perfectly, and the bolt will rest in a nicer spot on the edge of the breech. also, you gotta be careful, your bolt may be going back far enough to clear the whole front piece, and may jam once in a while.