I finally got my lvl 10 kit yesterday but I am having a helluva time getting it to work. I think spacer 1.5 is the right one to use, but now I'm all screwed up about what spring and what velocity I should use. When I turn the velocity up high enough so that the gun shoots every time, it get very loud and sounds like it is firing twice. This happens on both the stock sized spring and the middle spring. Speaking of the middle spring, which way should the cut side of the middle spring go? However, on the short spring at lower velocities, the gun will fire, but the bolt won't retract all the way and will need to be pushed in, or it will but there is a delay.
I'm also having problems with modifying a standard I frame to fit a classic RT. I widened the hole and it looks perfect, so I gassed it up, and got a big leak between the body rail and the body tube. I Notived that the area with the hole drilled in it was about a mm thicker than on my RT benchy, which works fine, so I started filing down that area on the I frame. It's now almost the exact same thicknes, but it still leaks. What's going on here?
I'm also having problems with modifying a standard I frame to fit a classic RT. I widened the hole and it looks perfect, so I gassed it up, and got a big leak between the body rail and the body tube. I Notived that the area with the hole drilled in it was about a mm thicker than on my RT benchy, which works fine, so I started filing down that area on the I frame. It's now almost the exact same thicknes, but it still leaks. What's going on here?
Comment