Just like the subject, when will it be available in the AGD online store?
Thanks.
Thanks.
-
-
Heres a custom one I had made for me on my Tribal![Something Cool is Here] -
Thats super cool! BUT! I am looking for one for an Emag.Comment
-
ok heres what I am gonna do. I am gonna take my center feed body to a hardware store and ask them to cut it down to the size I want. Just ask a local hardware store.Comment
-
Before you go cutting anything better check some things. I think they mentioned the no rise worked best with Halos. If you have a revy, it might not get the same benefit.
Comment
-
it's the Halo that works the best on a low rise. If you cut down your vertical feed mainbody, #1 you void it's warrantee, and #2 you should have level 10 if you DONT have a halo. A low rise with a revvy may end up with more skipped shots, or CHOPS if you don't have level 10.
There are a couple guys from AGD Pride that have thier mags setup that way. They seem to love it.Comment
-
When I do go cutting away at my center feed body and I will have a Halo B, I have lvl 10 installed.Comment
-
I was running a X-board revy with impeller on my no-rise and didn't seem to have to many problems that was before lvl10. You just have to set your bps alittle lower and kinda watch when the revy gets low. I got a chop every now and then because the blow back would affect the next ball. But if the hopper stays full enough I hardly notice that many chops. Now I have lvl10 and have a Halo-B on top and its just insane. Not a miss feed or chop, I drool every time i shoot it
Comment
-
Mental note: Never share a bunker with spacemanspiff, SFL+Halo B+drool with every shot = big puddles...
Comment
-
LOL... Big yellow rubber boots come to mind
Comment
Comment