Problem with Minimag need HELP quick!!!!!

[acecl22]

when i gas up my gun and pull the trigger nothing happens, i can feel that the trigger is pressurised but it doesnt shoot or even hiss, absolutely nothing happens.

[SlipknotX556]

Maybe your tank is empty, or your on/off assembley is missing something.

[acecl22]

i know i have air, and i think my on off assembly is fine, i just took it apart, every thing looks fine

[halo13]

maybe your velocity adjuster is just turned really really low.

[acecl22]

Ill try that hold on

[acecl22]

i Just turned up my velocity nothing still

[halo13]

is the safty off?

[acecl22]

yes the safety is off, i can pull the trigger all the way but nothing happens, the trigger is pressurized but it doesnt shoot.

[mxracer33x]

it is either your trigger rod length is wrong or the on/off pin is to long. Should be about a 1/16" gap between trigger and rod. I had that problem when i switched to an intelliframe. Hopefully that is.

[RTMAGBOY13]

take a dowel and push back the bolt make sure its cocked

[acecl22]

i cant do anything right now, im out of air, im using a 9oz co2 to do this, im not playin with that though, and i plan on getting a nitro real soon, Maybe that was the problem(not enough pressure)ill tell you guys what happens as soon as i get a fill, about a half hour

[lunchbox]

does it have a lvl 10 in it if so try messing with the configurations if not what type of trigger frame are you using.
take your valve off but keep the gun together and pull the trigger back is the seer pushing up far enough thru the hole the valve pin sits in? if not its your sear.
Shake your valve with the valve pin facing down (**caution dont shake to hard and shake into your hand parts may fall out***) did the on/off pin drop down thru the on off assembly bottom (this will fall down thru the on/off assembly by shaking on a well fit vavle.) if it didnt take the on off assembly out and see if the top o ring is holding your on off pin in the off position to fix it oil it up then put it back together (had this problem with my original automag,oil the o ring and see if it helps.if using a boo yeah frame the pin is 99 percent of the time the reason for no fire.)
well if none of these help you you need better advice but when my mini mag does what yours is doing its usualy the pin. i never had the sear problem but my friend did both real easy to fix. dont be affraid of the gun and takin it apart and tinkerin with it just remember what goes where when your done.
or just send it home for a tune up

[LJT]

Sounds like you don't have enough pressure to move the bolt. If you are using CO2 there is no easy way to tell. Before you try some of the other suggestions fill your tank.

[LittMag]

Either not enough pressure or your trigger rod is too short. My rod was too short when I got my Z-grip, All it took was a little lube and some turning and yanking to make it longer =P

(just make sure the space between your trigger and the rod is 1/16 of an inch or so.)

[cwuchu]

I have the same problem with my intelliframe that I just put in. The trigger rod is already pushing against the back of the trigger. Wouldn't turning the rod to see a gap make the gun even more unlikely able to shoot? I already turned up my velocity as far as it will screw in. I have the lvl 10 mod., but I put on the org. trigger frame and it worked fine. I have enough pressure in my tank also. I originally thought it was the trigger rod too, but I just got a new sear and turning the rod in just doesn't seem like it would help. I would also like some response to this issue, thanks.