Help... Emag capped with 12v rev xboard

[agdemagman69]

Ok, im going to cpx this weekend, and I might not be able to get a Halo B by then, so i was wonderin what the best number to cap my emag off is at for my 12v xboard.. thx

[xmetal2001]

Probably 10 would be fine.

[Strider]

I was using 12, experimenting with 13 before Level 10. Seemed to keep up, but I wasn't using top end tournament shell...

Now it's set to 16.
Go Level 10!

[TheTramp]

If you don't have a L10 I would set it for 11 just to be safe. You probably wont notice a decrease if ROF and you shouldn't have to deal with chops.

[Phil]

Before I got Level-10 I set it to 13bps and I stopped chopping all together. After L-10 like the previous poster I set it back up to 16bps and have experienced no chops. I have a centerfeed/xrevvy.


Phil

[athomas]

I have mine capped at 16 with level 10 installed. That way you can at least give a 5 -6 shot burst at full speed when needed. The only time the revy can't keep up is with sustained high shot rates past the initial burst. Most people don't shoot like that anyway.