making the air valve

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • steveg
    Member
    • May 2001
    • 460

    #1

    making the air valve

    Hi AGD/Tom by chance do you have pictures that you
    could show everyone on how the A.I.R. and RT valves
    are manufactured.
    Last edited by steveg; 10-08-2001, 07:49 PM.
  • steveg
    Member
    • May 2001
    • 460

    #2
    strange I guess no else is curious about how it's done

    Comment

    • AGD
      The man from AGD

      • Oct 2000
      • 5916

      #3
      Well its not very interesting I'm afraid. A bar of stainless steel feeds into this half million dollar lathe, a few minutes later a little door opens up and the part rolls out. No kidding.

      AGD
      sigpic

      Comment

      • HyperSnyper

        #4
        I use to always think that if you were a good little boy or girl, if you left your Blow back gun under your pillow, the AGD fairy would replace it with a Mag there for when you wake up.

        Now I dont feel so special... sigh...

        Comment

        • steveg
          Member
          • May 2001
          • 460

          #5
          darn I wanted to see what brand of turning center and barfeeder that was used. professional curiosity you see

          Comment

          Working...