Is an intelli possible here?

[Jack & Coke]

If the o-ring trick doesn't work, try this (I've done this):

Go to a hardware store and buy a washer ($0.05) about the size and thickness of a dime. When you screw in the stab, it will change the position of the hose line.

Good luck.

[shartley]

Originally posted by TheTramp


You didn't answer the question! What's happened to you!

An Intelliframe will fit with a Palmer Sab.

LOL I don't own a mini, so I don't know. It looks like it would be very tight and probably would not fit without a foregrip extender.. BUT, I don't know. That is why I didn't answer his question. Unlike a lot of folks, if I don't know, I don't just toss out answers.

I just clarified his question, since it looked like Spazzed missed it...

[battlegroup]

I don't have a stabilizer like that (mine connects directly to the AIR REG) But it looks like you could switch the port on the front and the back. take the elbow and the (I assume)burst disk (if it's not a burst then they should be interchangeable) out and look at the ports. if they are the same they can be reversed. put the burst disk towards the grip and hook up the elbow towards the front. the elbow will have to angle slightly off to the side but it should fit. If not then take another elbow and put it 90 degees to come out the side and then hook your hose to that. I'm willing to bet that they are interchangeable. This would be the best option because your not backing out the reg.

My first suggestion works on my gun because I have an aftermarket vert ASA that can be reversed because it has ports on both sides.

[petefol]

i would also recomend switching the asa around. you will have to buy a new hose but thats only a few $