mag parts on rt pro rail...

[MinimagRockin']

would standard mag parts fit on the light weight aluminum rt rail they sell at the AGD store? If not why? Also do they have a hole in them for a vertical adapter like on the regular mag rails?

[Telefragged]

RT & RT Pro rails are actually heavier than classic body rails. The foregrip mount is the 6 bolts to teh body rail, then another two to the foregrip, don't think a normal mag adapter will fit there.

[magman007]

hate to bust your bubble, but the one shown there is for an e-mag, there may be one for the rt pro, but i havnt seen it. Also, the e-mag one is not counter sunk for the vert asa. the old e-mag ones are, but these are not, as the area is too thin to support one

[MinimagRockin']

The specific rail I'm talking about can be found here: http://store.airgun.com/acb/showdetl...ID=324&CATID=6

also where can I find one of those RT gas thru foregirps?

[magman007]

ULE= Ultra Light E-mag..... that is an e-mag rail...


feel the rt, i have owned both, i know the rt rails have the countersink, and the stock e-mags do.... I was speaking about the ULE-mag body rail that was shown, the one i currently own BTW

[MinimagRockin']

If that is so AGD should change that text because in both the link from the store and in the description of the rail it says it's for the RT pro...

[MinimagRockin']

Ok just so I have everything straight then: I could buy a ule rail put all my standard mag parts on it, besides the vert adapter (i aparently need a flat rt gas thru) and everything will fit fine?