question for the other micromag guys out there

[FreshmanBob]

So I was playin a little paintball today and my micromag started double feeding, a lot. I'm pretty sure its the warp pushing the paint past the detente but I'm running a 9 volt and it's never been this bad before. Sometimes i wouldn't have a problem but sometimes it would double feed every trigger pull and I'd end up having to put my finger on the detente. Maybe it was just the paint from a previous game in there but I'm kina worried.

Has anyone else had any problems like this?

[paint king]

well....

This should probly be in the tech forum but since its here. Make sure your detent is in all the way and its not bent. Mine has been bent before. That would most likely be the problem.

[56kSomeGuy]

maybe your ball dent spring is worn out(I had a small feed problem with my micro-e double, triple feeding then i sent it to ptp and they fixed it up with a new spring for the ball dent and maybe a new ball dent:))

[-=Squid=-]

Assuming your detent is in working order, tighten it in more. PTP's lever arm detents get harder to pull and move the more you tighten them in. Make it real tight and see if it fixes your problem. If I rambled or you dont know what I'm talkin about lemme know, I will try to be a little more legible

[paintballbeaver]

I own a micro and work on my friends 2 that he has your problem is your ball deten either lost its little spring or if you have an old school one that comes off the gun it prolly needs to be tightened up or you broke your detent just call proteam the guys down there are awesome for tech support for the best gun around the micro