Quality control?

[Vendetta]

[LittMag]

You should be able to turn the back part of the valve to match up with the front part.

I have the same issue with the valve on both of my mags, it doesn't bother me. I don't think the small gap is a problem.


-Litt

[Vendetta]

I can turn it when the valve if off, but the little pin does not let me turn it when it is on the trigger frame.

[Thordic]

Its perfectly normal.

You'll never get them to match up perfectly, because the o-ring size can change slightly, etc etc.

[TheTramp]

Also, the little gap between the valve and the body is completely normal.

[Vendetta]

Thanks

The rest of the gun was so perfect

[Kevmaster]

yeh, i woudlnt worry about it, as noted, the orings change size throughout their life, so dont stay up late about it

[Blennidae]

The engraving on both my minimag valves lines up. Guess I'm lucky.

[HoppysMag]

mine matches up perfect, and i have no gap... i find it odd that they wouldnt match up, i mean i can understand the gap... but thats new to me...

[toymyster]

Due do inconsistencies in the Reg seat seal and rag body O-ring, the two halves of you valve may or may not match!!! Also check to make sure the Rail bushing is in place!! These items will not effect the performance of your marker at all!!! Hope this helps!!

[TRIAD]

OK!!!!!!