Evo II and Intelliframe

[Bront]

Anyone know if the Evo II can be hooked up to an Intelliframe like a Revy? I wouldn't think it would need it, but i'm curious.

[xen_100]

I am sure it can be done. I believe it uses a similar photo eye to detect paint.

[Bront]

So, how would you go about doing it? Anyone ever tried?

[personman]

I'm pretty sure the Evo II uses a Servo motor, as all Viewloader motorized loaders do(so you can hack in the same way as a revy). I'm sure it would work, I just dont have one to tell you how.

[xen_100]

I dont have one in front of me, but I bet there is a signal that comes from the photo eye sensor. it is going to be a high or a low (depending on how they wired it) when there is no balls and the oposite state when there is. All you have to do is tap into that signal and fake it out with the correct "no balls" signal so it spins with every trigger pull.

[digitard]

Possibly might wanna open up your EvoII and take a few closeup pics of the internals/wiring .... possibly someone will be able to identify it by that.

Just an idea....

Sincerely
Dave K

[Bront]

It's not my Evo, it was a question someone asked me, and I thought it would be an interesting idea. I'm suprised no one here even thought of trying before now.

[digitard]

Most people seem to have either a 12v Revvy or a Halo ... I haven't seen too many people with Evo II's on their guns ...

Thats probably the reason it hasn't been posted/etc commonly..

Sincerely,
Dave K

[Bront]

Anyone got a link to where the guide on how to do it on a revy is? I'll se what I can decipher from there.