can dye panels be intellifed?

[EsPo]

i am asking this question because i thought they were made of plastic, and i am worried that if i cut them, they will crack. has anyone done this?

[MindlessMicroMag]

your best shot would be to use a dremel to gring out the slot for the wire

[Load SM5]

You can use a drill but set the torque down to it's lowest setting. In case the bit does bite it it won't crack the plastic.

[Kevmaster]

id recommend a dremel to do it...although i recommended a dremel to my friend to mill his spyder...i ended up buying him a new body

[The Frymarker]

Actually I had dremmeled some hyperframe panels with an insert for the intellifeed.

If you get a diamond grinding attachment and set the dremmel on high you shouldn't have any problems.

Take care

Heather