L 10 is not my friend.

[Phil]

Pito- where did you get the wrap around emag grips?

Havoc- I used the carrier just below where it leaks as you suggested when It was installed originally. However, the O'ring breaks in and you have to go down one carrier size.

It is obviously different for different guns. Hence all of the extra parts. It is simple to install L10. It is not so simple to trouble shoot if your gun isnt working properly. Even AGD had difficulty with my friends gun, otherwise they would not have sent him his gun back functioning in worse condition. (He sent it back and they are working on it. I have ever had faith in AGD's support and don't want you to take this as me bashing their support people. In my experience they are good guys and have always helped me.)

[xmetal2001]

Originally posted by SyntaxError


Well, the first time installing an LX it took me a while, but I can do them in about 5-7 minutes now, kinda used to it. They're not complicated at all, just a carrier, shims, and a backing washer...

Exactly. Its not complicated, but when you first see all those little parts, its intimidating for a user looking not to tinker.

[demonguy8]

For me lvl 10 has been nothing but a disaster... It all started out with the beta where I got one of the like 15 defective bolts (the bolt pin thing wasnt out far enough) out of the 200 (not really mad seeing as how it was a beta test, and I didnt have money to play until after Id gotten the new bolt). Jump to the present...I use the 0 carrier (the one with no dots or lines if I remember correctly) and can still chop ANY paintball that I shoot.. Never had any problems with the bolt stick from such a small carrier UNTIL the MICT tourney (my fault for not thinking about the fact that the orings probably would react different to barely above freezing weather).. And to top it all off I can barely chrono my gun under 275 with the smallest spring/or the origional spring.. (which wouldnt be problem if I didnt frequent Country Club during the winter where the chrono speed is 250)

Then again I am that guy that LOOKS at an autococker and it goes down.. I think its from that time when i tripped over that black cat breaking a mirror while walking under a ladder.

[magmonkey]

I have set up 5 mags with lvl 10 and all but one work great ... the other one is a diferent story the gun still chops no matter what the setup on the other hand the other 4 guns are PERFECT

[RetroEclipseMan]

Yeah it sounds like you might possible need to adjust the length of the power-tube piston the on the bolt. I know mine was doing the same thing, no matter what i did it just wouldn't work. I checked the length of the pin and it too long. I decided to just end the gun back to AGD and have them set it all up and do it right and they did say that was the problem. I'm assuming it's working now but haven't gotton to use it since I just got it back.

Try to get a hold of a set of calipers and measure the length of the pin. If I remeber correctly it should be 2.01" long. Havoc, if this is wrong than let me know since I'm not positive.