how to cut macro..

[EsPo]

i always cut my macro with scissors, and the end of it always comes out all messy and rough.. then i end up sanding it for like a half an hour..

[blnk162]

wire cutters...

[Mr. T!]

Use wire cutters and when you are done, put some oil on the ends, so it slides and removes better.

[elpimpo]

i think razors work well

[painball]

I use my teeth for all my cutting needs.

[Tunaman]

No wonder you guys have a hard time with Macro...Scissors? Wire cutters? You have got to be kidding me. Use a Macro cutter or a razor knife.

[EsPo]

hehe.. macro cutter, i didnt even know they exhisted.. ahah.... plus. but will one of those razor things where the blade slides out do ok? also, how can i order parker macro on your sight?

[Kevmaster]

yes, thatll work fine...and a Razor is the only way to go...SuperKnives work good

[tranman]

I use one of these because i got it free, and it was meant to cut plastic tubing. It also makes the cuts perfect...no sanding need, it makes a perfect 90 degree edge.

[EsPo]

where'dya get that tranman?

[pbguy888]

I do mine the same as espo , and it comes out the same way... Why do I need to sand it?

[Sparq]

I have better luck with a simple sharp knife over a razor knife. I find the razor blades tend to bend and flex enough that it can be difficult to cut a straight edge. I just got a composite folding buck knife, works great.

[TNS2k2]

Cigar cutter, that or my dogs nail clippers, they are both sharp and make nice clean cuts.

[Python14]

I got some nail trimmers for a dog and oddly, they work great. The cut through it like a knife through butter and never leave it uneven. Works great and cheap too.

[Aliens-8-MyDad]

get a BoxCutter/Utility Knife they both work great