wallice9111 get's a new body, AKA how an FSE-LX is made Lot's and Lot's of pic's

[luke]

TKOMag123,
This is a Slug body made by AGD. Festuss33 did not build the ENTIRE body, he simply made flat cuts, then did the scalaps. (Which CAN be done on a mill.)

If you read the whole thread you will see that no "software" was used...

[FESTUS33]

Originally posted by TKOMag123
my dad wants to know what kind of maching center was used, what kid of software was used, mastercam? and why where the pictures were taken on a bridgeport? he thinks that you can't make that peice on a bridgeport.

All of the design came straight out of my imagination, and if he does'nt believe that that body can be made on a Bridgeport style knee mill, He,s more than welcome too come over {with a slug} and watch Me make another one.
I've been a machinist for close to 20 yr's, and the picture's posted at the beginning of this thread, were taken during the actual machining of this body.
Not trying to flame you're Dad, Just stating the fact's.
Rick

[Fatjon]

i dont know how he made it but it was one nice body. Sure did enjoy owning that piece of aluminum for the month that i had it.