Hey all, just wanted to once again give praise to th eLvl 10 kit. Best piece of equipment I have ever purchased for my mag!!!
I went to Atomix this weekend in Michigan. Of course bought the cheapest paint they had ( Big Ball ) I figure I was just flingin paint all day and not too concerned with accuracy.
I loaded up paint in my LOE EBlade FreeFlow, expecting the low pressure and eye to handle any problem I was having. Much to my displeasure, the bigball was turned into mush on every shot. I had installed a gated feed port on the gun, and use an older Revolution to feed it - well, the feed filter tabs had just enough catch on the paintballs that they would not feed when the loader was lower on paint. On top of that, the Big Ball ranged from about .689 all the way up past .693, so my EQ barrel system was utterly useless. The brown paint was rough for the eye to pick up, and with the bad feeding and odd sized paint, it was a total mess.
I grabbed my custom Micromag, dropped a hopper on it, gassed up, and ripped through 1800 rounds of this crappy Big Ball, did not break a single ball, fired pait that has flat spots and was already wet from other broken paintballs, still no problems!!!
Thanks again AGD!!! Now what to do with Eblade LOE Freeflow?
I went to Atomix this weekend in Michigan. Of course bought the cheapest paint they had ( Big Ball ) I figure I was just flingin paint all day and not too concerned with accuracy.
I loaded up paint in my LOE EBlade FreeFlow, expecting the low pressure and eye to handle any problem I was having. Much to my displeasure, the bigball was turned into mush on every shot. I had installed a gated feed port on the gun, and use an older Revolution to feed it - well, the feed filter tabs had just enough catch on the paintballs that they would not feed when the loader was lower on paint. On top of that, the Big Ball ranged from about .689 all the way up past .693, so my EQ barrel system was utterly useless. The brown paint was rough for the eye to pick up, and with the bad feeding and odd sized paint, it was a total mess.
I grabbed my custom Micromag, dropped a hopper on it, gassed up, and ripped through 1800 rounds of this crappy Big Ball, did not break a single ball, fired pait that has flat spots and was already wet from other broken paintballs, still no problems!!!
Thanks again AGD!!! Now what to do with Eblade LOE Freeflow?






Comment