Intelli Vs. Boo-Yah ELCD

[Hafter]

What will I be able to shoot faster with?
Intelli Frame /w Intelli Feed
Boo-Yah ELCD
Setup: Retro Mag, Fixed Output Nitro

[RT pRo AuToMaG]

I'd say they'd be about the same, and anyway Boo-Yah sux, the only 2 ways to go electro with a mag are centerflag hyperframe, or emag conversion! Go with the Intelli, or get a hyperframe if you want electro.

[Hafter]

IC
The reason im asking is I just bought a retro mag setup and it comes with and ELCD. Im trying to decide if I should sell it and get a Intelli.
What u guys think...?

[Hafter]

up

[Hafter]

up again

[hostage]

Well I encourage booyaahs, they are harder to configure but that is about it. The booyaah will fire faster than the intelliframe, also if your booyaah has been overhauled like I did to mine, it should out shoot most electro's.
-Doron

[Havoc_online]

the intelli frame will never go down on the field and is built AND warrented by AGD.

the boo-yah is not.

Doron, Do you have the equipment to flash/reprogram the board? Arent the boo-yah's capped at 16bps? how can that outshoot most electro's?

[Hafter]

Hostage: Overhauled, what exactly do you mean?

I guess I will just have to wait for my gun to come in the mail and try out the elcd.

How fast do you guys think ill be able to shoot in order to decide its better than an intelli frame with intelli feed?

[hostage]

Well most of the problems that plauged the boo-yaah, I fixed. I made a 9.6v battery for it that I have only charged once in the past couple of months and it was not even low then. I also intellified it. I made the trigger pull better, by placing a better microswitch and put a set screw in the trigger, as far as firing. I can pull about 12-14 max on my booyaah, but on my timmy w/ was board I can only do 9-11. When I use turbo mode it shoots faster than 15 and only full auto is capped at 15. It is all depended on you preferance, I do say that any manuel trigger frame will be more realiable, but since I know my booyaah well I won't have another issue with.
-Doron