Benchmark Trigger Washers?

[magmonkey]

I have taken the side slop out of several benchmark frames

the hole through the trigger is way to large for the pin that holds it so what i did is I ground some stock to fit the trigger (leaving a couple tenths so it will still move on the pin) and then lapped the hole through the frame to fit the new pin ... it makes for a much nicer trigger pull ... but if i were to do it again i would have bought a intelli frame outright

[madmatt151]

Benchy slop...

My Benchy's slop isn't that bad, my complaint is the trigger rod seems to move up into the trigger. Is this common?

[FalconGuy016]

Ahah I just got my intelli today
I was a little surprized that the trigger is stiffer than the benchmark, but no biggie I loves it now

[BTAutoMag]

Re: Benchy slop...

Originally posted by madmatt151
My Benchy's slop isn't that bad, my complaint is the trigger rod seems to move up into the trigger. Is this common?

yea thats the reason the triggerpull is so long...

the purpose, to make the trigger pull smooth

[madmatt151]

Ewww!

Is there anything I can do about it? Can I swap th edouble trigger from my original frame to the Benchy? I forgot the manufacturer, I bought it years ago. The pin size looks the same though, willitmake a difference?