Sending in Automag for level 10 installation

[Vengeance]

Does anyone know if sending in an automag to get level 10 installed is the best way to go? I figure AGD can do a better installation job than me, and I have the means to do to send it in. Anyone know if they do a better job than a makeshift installation?

[FalconGuy016]

You should do it yourself it would be the same

[Xerces]

its not really hard to install, it just takes some time to get it tuned the way you like it.

[spazzed]

Only difference is they've done it before

You'd be better off doing it yourself, it'll give you some experience with it, which you'll need to tweak it as everything beaks in

[Kevmag]

I don't consider my self very mechanical, but I was able to install Lvl 10 on 2 mags. After retuning after my first day of playing they continue to work fine.

Make sure you have your tank full. You'll lose quite a bit of air when tuning L10. Read the instructions carefully and take your time. Again make sure you have plenty of air.

[minimag187]

Im only 14 and I installed level 10 on my old mag, worked like a charm with no chops. You should do it yourself.

[yeahthatsme]

it took me five days to install my inteli-feed connection, and 10 minutes to install my level 10. i say you should do it yourself so you are familiar with how it is set up.

[Miscue]

http://www.automags.org/~Miscue/level10.mpeg

Right Click -> Save As

Installation is easy... even I can do it.

[rdb123]

I remember Jon telling me that AGD has a 25 dollar Level10 installation fee; it was waived in my case since I've got an SFL though.

-Ron