How heavy is your full gun-setup?

[56kSomeGuy]

Finally I have finished my set up(maybe a new barrel later) and I weighed it. When I did I was shocked to see that my whole setup weighed a little over 10 pounds(micro-e, barrel, evo II, drop, and 88/45 crossfire). So this made me wonder is my gun heavy or is this the average weight of a set up.

So I would like to know your set-up and how much it weighs without paint.

[LawFox32]

my setup is heavy as a beast; which normally isn't a problem b/c I should the marker real hard so it doesn't seem heavy then, but other times its a beast

[Cliffio]

well my 91/45 maxflow makes it alot heavier than it should be

[AlabamaMan]

Last time I put it on the scale it was between 9-10 lbs. That was Rt-Pro stock warp + revvy + 68/3k flatline. Since then I have done some milling and currently i'm trying to find a new forgrip. So hopefully I can get it down to less than 9 lbs.

Aluminum shavings = good

http://www.automags.org/forums/showthread.php?s=&postid=665172#post665172

[EsPo]

gun in sig = 12 lbs+ its all because of that big arse apoc reg

[nicad]

machined down micro mag, lightened hyperframe, homemade aluminum valve, palmers reg, 10" AA barrel, tiny dropforward: 1 lb, 15 oz.
this is everything except hopper and tank. for those i run a gutted revvy intellifed off the hyperframe, and a little 45/45 crossfire.
i think the totoal is around 5 Lb?

[mtnkid82]

I think mine was about 11 lbs last i checked w/ a hopper of paint . but now that I have the x valve I think it is a little lighter.

[�.C.]

with or without paint? Also tank filled or not filled?

[LittMag]

Mine is also a beast, Stock Mag, Warp, steel crossfire68/3k stub, Revy, all this is around 10 pounds, add paint and there you go.

-Litt

[Koosh]

68 Classic, Full 20 oz tank, Half filled VL2000, Warp, 14" SP AA, Palmer Sideline Stabilizer, Gadget grip, and Dye Gripframe = 10 pounds

[Ultimator]

My Impy's actually very light. I'll weigh it later on.

[magsRus]

Angel IR3
Kapp dropzone
Freak Kit
68/45 Crossfire
..pretty damn light

[FalconGuy016]

Originally posted by nicad
, homemade aluminum valve,

How did you make your own valve

[who_311]

WOOHOO! 7 lbs 12.5 oz with paint, hopper, barrel, and a full tank(that air can add up!).

[nicad]

"How did you make your own valve"..

http://www.automags.org/forums/showt...threadid=59051