Hey guys, I have two main ideas in mind, and i need your input, vote above about how you want the whopper. The original dimensions of a warp & revvy is about 9-10" high, 3-4" wide....
-
26Around 5-6\" tall, 4-5\" Wide0%21Around 4-5\" Tall, 5-6\" Wide0%5
-
Instead of the Warp vertical, why not have it horizontal?
Put the Warp under the loader, then it would be ambidexterous. -
wont work nippin, the balls would get caught in the tube that is bent, and it would be waaaay too much work
Comment
-
*drums keyboard* You can't do this with a working warp. the design of the warp rather precludes loading from the side. Unless you run the warp backwards.
as I said earlier, I should have stuff in the next 3 weeks. a smaller warp.. and then the shell is elementry.To be an AGD supporter, one cannot be an AGD bigot. -Nero
Truth is a complex thing. One must govern by simplicity. -M. Mercier, special counsel to his Majesty for domestic matters. The Brotherhood of the Wolf
"You can't outrun Death forever, but you can make the bastard work for it."
Comment
-
Actualy it is going to work, just need to finish up the battery pack mod and melt up the hopperComment
-
LoL....
I am so anticipating Pictures of the prototype.... WORKING prototype at that...
~da ballerComment
Comment