WARP users please vote on a new drop!

[Jerhew]

ok i have the perfect solution

just put some screw holes in the bottom half of the drop directly under where they would normally be... you can then attach your original warp bracket on the very bottom
just include some screws just long enough to attach the warp without bottoming out...

so you can use the drop whether you have a warp or not...

you might have to make the drop go down a little further for tank clearance...
but other than that...
seems like the perfect solution to me

[thecavemankevin]

you should make the bracket like the one below... There are some benafits to this.
1: If you have a stubby tank, you warp wont have to sit out real far creating a fat/wide gun.
2: It creates a rather short feed tube thuse less bending in the hose=less ball friction=faster feed times. Not to mention no need to alter your hopper in order to get a tight fit.



more pics of this set up at:
|The Club

[thecavemankevin]

Re: ok i have the perfect solution

Originally posted by Jerhew
just put some screw holes in the bottom half of the drop directly under where they would normally be... you can then attach your original warp bracket on the very bottom
just include some screws just long enough to attach the warp without bottoming out...

so you can use the drop whether you have a warp or not...

the reason he cant do that (or it will mess up his current design is because of the screw