slide check shootdown?

[TheJester]

i recently put a slide check on my mag, and i've noticed a little shootdown/inconsitancy, more of inconsistancy, i've had it shooting +/- 3 fps before, but my last game(sunday) i was shooting +/- like 10. can i just drill out the holes in the slide check to make them bigger and have a larger higher flow rate?

[Me]

it would make sense because the holes are so small. I dont know about the drilling

[jayloo]

You coud always put the slide check after your air/valve connection. This way it can sill release the air pressure form the line but not limit the flow between the valve and air system.

[TheJester]

ummm, how would that work? the air still needs to flow threw it to get to the valve. and i have it directly on my valve, well it's on on a 90* elbow attached to my valve

[Tom Sparkman]

A larger hole might cause the o-ring to get cut. Instead, add another one or 2 small holes around the shaft. Be sure and debur.

Tom

[jayloo]

Jester...put a t-connection on your valve or air tank.