red loctite

**speedyejl** · 03-29-2003, 11:47 PM

I think there is only one last resource...

Throw the VA and gauge in to an inferno of burning napalm. I would recomend 3 min in the inferno of course.

**personman** · 03-29-2003, 11:49 PM

I think you should use the lighter again, excpt this time use bug spray

Or you could stick the tank in a pot of boiling water, but that mit make the reg unscrew

**speedyejl** · 03-29-2003, 11:54 PM

I say Napalm...

vs

**IcantBelieveit** · 03-29-2003, 11:58 PM

dude you can get and adjustable wrench on those gauges my friend. the samll pair will work. see the flat sides on the gauge? You can get an adjustable wrench on that

**EsPo** · 03-30-2003, 07:28 AM

its red... i got owned.. so did my father

i do have an adjustable wrench on it.. and after you start pulling really hard, it slips...but a few times it didnt slip.. i just gave up.

**IcantBelieveit** · 03-30-2003, 08:41 AM

put it in a vise, and try that, or try some vise grips. Why are you taking it of anyways? and are you sure, some lamer did not cross thread it in there?

**EsPo** · 03-30-2003, 08:56 AM

no.. its on my friends maxflo reg(he had an imp.. got a maxflo tank, gaveme his reg).. he said i could have the guage for the back of my imp.. seeing as i need to know the input of the lpr.

this entire time its been in a vice...

can i send it to one of you guys to do it for me?!

**speedyejl** · 03-30-2003, 09:32 AM

I'll do it for free, no fee for return shipping. Email me if your intrested.

[email protected]

**FutureMagOwner** · 03-30-2003, 10:01 AM

i assume this is the brass punk i had to deal with my dad ended up getting pissed and smashed it with a a hammer and drilled the center out and cleaned off the rest of the crap and retapped it for good luck

**speedyejl** · 03-30-2003, 10:24 AM

Brass? nahh, its a SS micro-gauge here.

**IcantBelieveit** · 03-30-2003, 10:26 AM

i will also do it for free, just let me know, doesnt matter

**PurePower** · 03-30-2003, 10:54 AM

Espo. Heat it up then get the proper fitting wrench not adjustable. Put the wrench on try to tighten it then try to loosen it to take it off. If that does not work Get a piece of pipe and put it over the wrench so you now have a huge lever and try to get it off. One of these will work. Good luck.

**rehme** · 03-30-2003, 11:17 AM

yeah are you turning it the correct way lefty loosey righty tighty

**magmonkey** · 03-30-2003, 11:58 AM

NAIL POLISH REMOVER - it takes off red loctite

**IcantBelieveit** · 03-30-2003, 12:44 PM

Originally posted by magmonkey
NAIL POLISH REMOVER - it takes off red loctite

along with any type of nice finish

red loctite

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment