I'm designing my plan for my mag setup and have one question. If I ran a CCM locking-feed on the ULE, would it be better to get the hi-rise or low-rise? I'll be using a retrovalve/12v revy combo so speed is very important.
-
Ditch the Rev get a Halo or Egg2 and get a low rise.
-RobertServing AGD customers since 93, wishing I could beat some common since into some of them about 5 hrs later.
MCB Feedback +35 --+-- Automags.Org Feedback +25 --+-- PBNation Feedback +24 -
low rise will provide a smaller profile, but from what ive read, a high rise may provide faster feeding due to a bigger ball stack ect.. id go with lo rise. not sure if a CCM clamper will fit.. it will if they make them in angel threads. www.chipleymachine.comComment
-
get the no rise
Comment
-
4 weeks for no rise
i just mailed them on this very subject and they said it would be about 4 weeks for the no risesAKA Tech
Air Force Won
AIM thejodusComment
Comment