Basically the SFL,XMAG, and Micro emags are basically the same. The only major difference are the removable breeches; can the PTP body and trigger frame be milled out to fit a PTP micro emag? If anyone has done this or can do this let me know.
-
President and Founder University of Dubuque Paintball Club
Lambda Chi Alpha
Student Gov't Rep.
Student Gov't Liason
Flight Center Dispatch Supervisor -
I suppose anything is possilble. You would have to mill out the grip frame and mill out the hole into the breach but I do not think you could easily clean the thing if you had a ball break. Then you would need to wire it and try and route the switch out if you wanted that. And then reprogram the board as well.
But you do not realy need it. Just get a level 10 in there and its not realy something worth doing then. -
i have lvl 10. I was just wondering. I know it would take work but it would also be a way for AGD to make a little extra money putting ACE in the micro emags.President and Founder University of Dubuque Paintball Club
Lambda Chi Alpha
Student Gov't Rep.
Student Gov't Liason
Flight Center Dispatch SupervisorComment
-
But then that would make them responsible for the bodies when they are not now... I do not think they would touch that.
This is not a deep blue type subject so I am moving it out to talk...Comment
Comment