Rail Drop Phenomenon

[dcmander]

DB, could you please take a closeup of the bottom of your grip frame and the CP rail drop. :)

I am planning to run a CP rail drop on my setup which will consist of an intelliframe with a 68 Dynaflow. Would this work? Do you know if the dovetail on the dynaflow would fit ok with the CP rail drop?

Also I didn't know CP came out with a new rail drop. Do they still sell the old one? Do you know the height of both of them? I would like it as short (height wise) because my only intention of running the CP raildrop is to match the dovetail of the dynaflow w/ the intelliframe. I would like it short as possible.

What do you think I should do if I want it setup this way? The old CP or the new CP or what?

Also is CP's site just down, or did they get a new address?

Can anyone post a link and make sure it works when they post it ?? :)

Thanks!

[DiRTyBuNNy]

I'll post a closeup of the two drops (old on top, newstyle on bottom) but because of my flash it may not turn out that great. I'm willing to sell either of my two drops..you can contact me about them in PM. I go to these tourneys all the time so it's easier for me to get one than for someone else to try and find one)

[scud2519]

I think this is a great bottomline (not mine, found it in the pbnation pic thread)

[Mr. T!]

My rail, good stuff, with a 68/45 and CP on/off, straight pro

Your sig image is way over the acceptable size. Please review the sig image rules

[Jack & Coke]

Yo DB, check it out:



I LOVE this low profile setup!

70/4500 crossfire "peanut" + Uni-Mount is great!

The tank sits nice and tight against my shoulder (good stable pivot point) and just under my chin (with mask on). This gun is close and tight and my wrist can slide nice and snug up verticle next to the tank reg. This allows me to get my elbow in tight. The 16" actually doesn't seem that long because the gun is now much closer to my body. The 16" length actually feels more balanced since the ULE is sooooo light. With my 12" barrel, the gun becomes "back" heavy.

I got the single trigger 45 frame from JAM! It works great! Excellent short pull (uses the same trigger as the stock frame).

Instead of a rail, I'm using the CheckIt Uni-Mount.

This is a GREAT mount! When you de-gas your marker, this mount bleeds off the residual gas held in the line due to the Level 10 via built-in check valve. No more "pop" as you try to release the gas via DQ.

[DiRTyBuNNy]

So what size tank cover on your peanut J&C?

[Jack & Coke]

It's a VERY snug 45/4500 Dye Rhino Cover. Not a problem at all to put on.

VERY comfy cover..

[Jack & Coke]

btw, Mr. T, nice image in your sig... 678K ?

[DiRTyBuNNy]

Cool..I may have to go pick one up...