PTP Warpfeed adapters!

[Peach]

I have ULE body... And I'm wondering about the different ways people have their PTP adapters set up on them.

A cool thing would be, if someone has these capabilities, to thread a feed tube, like the one on the ULE body. Except, this feed tube would be smaller in diameter so the PTP product adapter with the tightening nut would go on easily. If this was possible... There would only be an inch sticking up above the gun, except for two.

I'm sure if someone made something like this they could get some $$$ from people who want to use a warp on their ULE's, but dont want a two inch stack rising off the gun which is not neccisary.

_james

[WickeDKlowN]

Just get one of the old stock Angel feed tubes. They should be small enough to fit in a PTP adapter. And if it's too tall for you, just cut it down. The adapter will cover it up.

[misfit]

ptp used to include an angle feed neck that was really short and would do that exact same thing

[Peach]

Yeah thats what I was thinking of.. But I couldn't find one. Do you know for sure that they still sell the short angel feeds?Just need to get this figured out... Order the emag intelli-warp wire and cut down the eggo2 feed tube and I'm set!(Then I just need an x-mag, or a new board and full ule setup... ahh the wonders of new products visualy satisfying... but my wallet doesn't like them.)

[govnamac]

Call ptp, thats what I did, and they sent me one for $11.

[Peach]

alright thanks