No more crappy yellow pin..
As many of you know I have been working on an on/off switch for the e-mags. Below is the first run on the boards. The switch is pointing up because I have not drilled a hole in the side yet.the board wire will also be changed .
-
"It's my buddies gun"
"I just bought it"
"It came that way"
"I borrowed it "
I HAVE HEARD THEM ALL, SO BE ORIGINAL !!!
My gun says I'm holding it back from doing great things ...
-
By Jove! I think he's got it!
-
very cool kayle...
--SpydarmA Sanchez Machine Distributor
Ask me about my US Armed Forces, Law Enforcement and Fire Department Discount
PBN Feedback
AO feedback
EBAY feedbackComment
-
i wish i knew what i was looking at.Comment
-
looks great kayle
thanks again for the help in chicagoAka tech
Chuff
ChuffComment
-
i beleive this is the switch, if not, i'll remove the picture so it wont confuse people.Comment
-
GOOD JOB KAYLE! too bad i already have my sfl! heh, btw when do you get yours???
Originally posted by Tom in reffrence to a post saying he acted like my dad...
"That's right!
WHO'S YOUR DADDY!!"
ALL QUIT AND NO GO!!! Team Icky Forest-Shatnerball 2003!!!
www.tunamart.com
DONT SUPPORT HYPOCRITICAL MISSLEAD YOUTH, BOYCOTT HK
Comment
-
um, why all the circut board crap? i just took a switch off of a revvy board and used it in my e-mag...Comment
-
Cool, this is what I was looking for for an E-Mag. Is the swithc going to come standard on the E-Mag/X-Mag in the future? Or, will it be available as a retro fit for those who already onw E/X/SFL-Mags? Let us know man!!!!!!!!!!
Thanks, BregGiant flying dogs are gonna give you a flame-thrower enema!!!
SUPPORT YOUR TROOPS!!!!!!!!
Chuff!!! Chuff!!!
ABQHCComment
-
I built this as a project on my own..The reason for the circuit board is the switch is only rated for .4va . AGD says the current draw is too much for just a switch to last.As far as I can tell this will fit all emag frames without a modification . You will just have to drill a 3/16 hole to reach the switch."It's my buddies gun"
"I just bought it"
"It came that way"
"I borrowed it "
I HAVE HEARD THEM ALL, SO BE ORIGINAL !!!
My gun says I'm holding it back from doing great things ...
Comment
-
Hey Kayle, anything new with this setup with the on/off switch ? If it works ok, will it be available to the rest of us Emag owners ?Comment
-
-
The boards will be done this week and the parts are getting quoted.. The only thing thay will have to be done is to drill a 3/16 hole in the e-mag frame.. Looks like the cost will be around $35.00"It's my buddies gun"
"I just bought it"
"It came that way"
"I borrowed it "
I HAVE HEARD THEM ALL, SO BE ORIGINAL !!!
My gun says I'm holding it back from doing great things ...
Comment
-
Obviously I assume it's held up well while you've tested it. Where did you mount the switch ? Do you have the option of mounting it in different places ? What's involved with mounting the board and wiring ?
Do you have a picture of it mounted on the Emag ?Last edited by CFD323; 06-18-2003, 11:23 AM.Comment
-
externally this switch will look identical to the on/off switch shown on xmagsAka tech
Chuff
ChuffComment
Comment