Evolution 2 intellafeed?

[willboy_2]

Just wondering, is it possible to run an intellafeed from my intellaframe to my evolution 2?

[heftylefty]

yes it is possible, but it will just slow the egg down. i would just leave the egg how it is.

[RRfireblade]

Re: Evolution 2 intellafeed?

Originally posted by willboy_2
Just wondering, is it possible to run an intellafeed from my intellaframe to my evolution 2?

No real intellifeed options without adding your own control board.Can't time it with out it.

Jay.

[Lone Wolf2]

yes it is possible, but it will just slow the egg down. i would just leave the egg how it is.

No it actually wont slow it down it makes it ALOT faster...And down at TAG we have done this to about 6 evos to run on our speeds and it will keep up 22+.But we use the voltage from the battery to spin it.But thats just on speeds.

[RRfireblade]

How do you control the speed/timing of the motor to keep at 1 feed per motor start +or- the gap?I've never been able to get the motor to stay in time on its own.It would usually go off and jump or jamb balls.I finally had to build control board to keep the feed rate timed w/ the motor using the eyes and a trigger on the motor shaft.It didn't quite seem worth the effort to me.Just curious how you guys handled it?

Jay.