EMag 2004 again?

[JAM]

Hey everyone, well, it's fri, I'm bored at work and decided to revisit this topic... I was thinking of an XMag-type one piece body, but with easier/cheaper milling, no eye and no removable breach. The ULE bod is a nice retro fit, but AGD should do something a little more visually pleasing. my thought for today:

[JAM]

full pic w/barrel....

[68magOwner]

that looks really cool, i wouldnt get one beacuse of lack of money, but its really nice anyway

[Benfica4ever]

That looks awsome, i hope agd really looks into that, that would be even bette4r if it goes into production.

[SIGSays]

so much talent... looks great! you use photoshop?

[fire1811]

that would be even better with the milled battery pack

[acecl22]

it looks as though the rail and body are one in the same, but what about the sear, i dont know much about emags, but on my gun you need to take off the rail in order to get the sear out

[CoFFeY[NiTrO]]

Thats cool, but the lines kinda throw you off, all the litttle kids with cockers would think its just a PTP.

Waht ever happened to the other 2k4 emag??? omg that looked better than xmag IMO

[LittMag]

The only problem I can see with the body is that you'd have to mill a slot for the sear. I dunno how milling machines work, but it would seem rather difficult when you look at how a slot is cut in the rail especially if it's one piece.

On the other hand, it looks really nice. I'd buy one if I had a job. =P

[nippinout]

JAM, personally, I would love to see modular breeches for it.

And with a unibody rail/body combo, you can easily throw on an ACE board.

[TheTramp]

I think it would be a great idea. Clean easy milling without the removable breach and no ACE would really keep the cost down.

[JAM]

hmm, thoughts...

well, I think that if you add interchangeable breeches, it would be getting into XMag territory. same with the ACE.

When I had my XMag, I only used a HALO, so I didn't need to switch up the breeches, I suspect most people use one or the other, but don't frequently switch between them.

I think ACE is not necessary, so it would save a few bucks on manufacture.

For everyone that wonders about the sear, it it held in place by a screw-in pin through the body- just like the XMag.

just screwing around,
j

[WickeDKlowN]

I think I like the first oen better, but it might just be because of the color... Although it does look alot liek something PTP would do.

And I think the no-ACE and non-interchangable breeches is a good idea. I see no real need for ace with LX, kinda overkill IMO.

[dcmander]

If AGD made new emags with a one piece body instead of a body and rail, I think they would sell a lot more.

I've seen many people turned off by emags just because the body and rail are two separate pieces. I know it made me wanna go to PTP, just so there is no hassle.

[FooTemps]

I say that a once piece body would be good too... making it look different from an xmag and ptp body is the issue.