Dallara final body from Deadlywind

[Taco]

awsome

[FooTemps]

Originally posted by ah137
I think it would flow better without the line and dots circled here

~Hills

there's too much flat on that spot for the overal body, it doesn't fit right.

[kenndogg]

wow..maybe this will finally give me a reason to invest in a mag....

[USAF-Flyboy with a Mag]

Nicad...Ijust wanna say that looks F'in AWESOME

[nicad]

hey Ken whats up?

sorry about not posting in a while yall.
im still alive.. but have been locked in a room hammering out toolpaths for this thing.
to answer a few re-occuring questions:

yes it would be possible to mill an Emag rail with this. I dont have one here so I havent been able to spec one out and model it to carve on. Im sure this is something we will take care of in the near future, cause this would make a VERY nice Emag setup.

they will be available as soon as i run proofing paths and multiple test runs on both the bodies and the rails. im working extra hard on this design to get the milling cost and cleaning/polishing costs as low as possible. Since this design incoperates the rail (it doesnt HAVE to, the body will work just fine on any rail you already have), that alone adds to the cost.


I plan to mill the first Dallara body/rail in the next few days. I assure you I will post pics asap!

back to work..

[rikkter]

i'll give you my emag rail if you need one to get the measurements if you need it. cause i oh so plan on getting one of t hese

[arowmic]

Kenndogg! Sup man.

[kenndogg]

nothing much man, just chilling. didn't see you out at pov this past sunday. well enough of cluttering up nicad's thread.

[FooTemps]

... I think agd should make sluggo everything... then i could get a matching dallara y-grp! haha

[Creative Mayhem]

Let me start by saying, "It's not that bad..." and then let me say... "looks good on a Cocker." JK man, sorry to see you spend money and get a poor job. Hope it works out for you the next time you decide to anno it.

CM

[rikkter]

Originally posted by Creative Mayhem
Let me start by saying, "It's not that bad..." and then let me say... "looks good on a Cocker." JK man, sorry to see you spend money and get a poor job. Hope it works out for you the next time you decide to anno it.

CM

lol eh, why do i get the feeling you posted this in the wrong thread?

[shinobidice]

would it be possible to have the people send you rails to mill that would go with thier bodies? like say i send you my rail and $x then you send me rail + body? Theoretically it should work out fine if they are milled seperately but so they match up right? or would you need to do them together to make sure they mathc up?

[Blazingace]

All I can say is SIGN ME UP!!!! You got a definate pre order here. I think that is the best effort anyone has done to date. PM or E-mail me with details of what you need to get one of these started for me.

[nicad]

it should be theoretically possible to to mill the rail seperatly.. but couldnt gaurentee a perfect alignment.. should be close enough tho.

have been and still am working on getting one of these properly milled out. slow progess...
will update again later.

out!

[gibby]

HOLY MOTHER EFFER! That body/rail thing looks sweet!! I would buy that in a heartbeat! Hrm...can you do that with an Emag rail too?