Will I be able to put the x valve into a micromag ??
-
-
Yes. It will fit.WE ARE DEADCELL, AND WE WILL RUN THROUGH YOU
Dayspring - "We've had Clare at Shatnerball." "I'm confident that she can take 20 guys."
"I'd trade my cocker for some steady pu**y" -
might have to play around with the on/off pin thoughYou are the Wormtongue of AO.~bofh
Comment
-
Okay I'll byte why do i have to play with the on/offOriginally posted by wyn1370
might have to play around with the on/off pin thoughComment
-
As far as PTP goes, they don't use the same spec pin as other E's, not sure about non-E's. If I remember correctly, they might even custom trim each pin to make the specific micro work. Might want to hold onto the on/off pin that is currently in the micro you've got just in case.Originally posted by sbpyro
Okay I'll byte why do i have to play with the on/offYou are the Wormtongue of AO.~bofh
Comment
-
Yes, just keep your pin. If the xvalve doesnt work, go for the old oneComment
-
So this is in regards to the on/off pin for emags being different. I don't think that would be a problem since it isn't a microemag. It is an old micro mag (no e or rt on it)but I will keep the on/off assembly jic.Originally posted by wyn1370
As far as PTP goes, they don't use the same spec pin as other E's, not sure about non-E's. If I remember correctly, they might even custom trim each pin to make the specific micro work. Might want to hold onto the on/off pin that is currently in the micro you've got just in case.Comment
-
you don't need the whole assembly, just the pinYou are the Wormtongue of AO.~bofh
Comment
Comment