Few questions about an old RT and a z-grip

[BigMatt-MadCustoms]

OK I picked up a original RT and it has a z-grip installed,just got it back from AGD for a total rebuild and a Level 10 install..

Ok the guns shoots great in this setup but I am just to old school to use this funky Z grip,not to mention I have have a bad wrist and it hurts to hold it..

So the questions I have are..
#1 Can any Mag frame be used on this gun as a replacement??

#2 is there a way to get more reactivity out of the trigger?? Or should I just crank up the opperating pressure? The gun says 800psi max but I thought I remembered hearing about people running them up to 900psiish' and having them run better..

Any thought would be most helpful..

BigMatt
MadCustoms
Coordinator for the
Virginia Division of the Paintball Marshals

[A to the G-Dizzle]

I don't know if you would be interested, but I have a stock RT frame that I would trade for the Z frame. If you have any intrest contact me.
[email protected]
mrdistortionzz <~AIM

[cheetah256]

you'll need to get a frame for an "RT" mag. your best bet is to pick up an intelliframe in the AGD store. because of the banjo bolt, the hole for the field strip screw needs to be bigger. your RT z-grip can fetch quite a premium in the bst forum though, they're pretty high in demand. might even be able to do a straight up trade for an intelliframe.

[FalconGuy016]

An intelliframe for the RT would be best.

[tony3]

I sold my rt zgrip for 132 on ebay in march

[A to the G-Dizzle]

Scratch my offer, I didn't know thet went for so much

[tony3]

Yeah, usually you should be able to get over 100, I got pretty lucky I think

[Blink]

Yeah, I just got a Z grip, from trading my intelli.