i just got a brand new pmi 68ci 4500 psi HPA tank and ya know that clear coat that goes around the tank well mine stops a few milimeters from where the regulator meets the actual bottle... is this ok? what should i do?
-
Last week i thought i was indecisive, but now im not sure anymore... -
Is there a neck of the bottle before it meets the regulator? -
yeah there just isnt a clear coat the last few milimeters of the bottle neck before it meets the regLast week i thought i was indecisive, but now im not sure anymore...Comment
-
i think mine's like that.
Just make sure to check it every once in a while incase it starts unravelingComment
-
yeah, do you think it would be bad if i rapped a piece of electrical tape around it to keep it from getting worn down?Last week i thought i was indecisive, but now im not sure anymore...Comment
-
Yes, then you couldnt see it in case it was unraveling. And... electrical tape wont do anything.Originally posted by f3rr3+
yeah, do you think it would be bad if i rapped a piece of electrical tape around it to keep it from getting worn down?Comment
-
i would still check it, its just that those few milimeters are the only part not covered by the tank cover so i would just put a piece of electrical tape to keep general wear and tear from happening to that part of the tank, i say electrical because its black :PLast week i thought i was indecisive, but now im not sure anymore...Comment
-
I'd suggest calling PMI and reporting it. If its a manufacturing defect then they should replace it and if its normal you shouldn't have anything to worry about.Comment
-
Its fine, my pmi is the same way. Over a year and its just the same as i got it. Just use a tank cover.Sadly the mag is gone, moved on to an LCD Trix
Originally posted by Nachos
I don't care if you need a special plastic that comes from a tribe in the amazons that can only be crafted by Willy Wonkas Oompa Loompas in his chocolate factory.Comment
Comment