Angel thread size

[Spray Painter]

What is the angel thread size and what tap size would i use to tap the hole that an angle threaded feedneck would screw into in. also what is the hole size prior to tapping for the angel threads?

[elpimpo]

what r these holes u speak of. im so confused

[Spray Painter]

the hole that the threads on this
would fit into

[elpimpo]

i thought u were talikng about a barrel. try postin in the angel forum

[nicad]

M21 X .75 6H tap is what your looking for.
or mill the threads with a single tooth tap.

gobs of good info on lots of markers can be found at:

http://www.airsoldier.com/~haveblue/tech/

they dont specify the 6H tap, but Iv seen it on two other places with a reasoning, so im going with that.

out!

[Spray Painter]

thanks nicad, that's exaclty what i was looking for