micromags! :(

[smilestyler]

Go search in the tech forum, I saw it there how I think it should be fixed. Sorry can't find the link.

[muirtach]

Hey there Penguinepunk555. They have it right. I had set the pin in there with a bit of epoxy. It was removed because all teh internals were switched to my Warp ULE set-up before you bouth them.
Just be careful with the epoxy. A little bit will hold it, too much can lock the sear in place though.

[RoadDawg]

Pictures would also help.

[penguinpunk555]

thanks for the help guys how much epoxy should i put on there?

[muirtach]

just a thin coat on the last bit of teh pin to go in place, enough to make contact on the sides of the pin hole

[penguinpunk555]

thanks again guys